Under Armour TriBase Reign 4 review

We believe that the UA SlipSpeed is a gem for people in search of:

• an all-in-one shoe: a home slipper, a gym trainer, a casual sneaker, a practical travel shoe, etc.
• Leggings Under Armour Legging 2.0 branco
• a BOA lacing that is very quick and easy to adjust

If having a collapsible (drop-in) heel is not a must and you need a full-on training shoe for intense workouts, it is better to skip the SlipSpeed.

When your training regimen calls for the most stable and supportive footwear, we highly recommend the UA TriBase Reign 5.

And if you don't mind other brands, the Under Armour 670 and the Reebok Nano X4 Emplea la tecnología CoolSwitch de Under Armour.

The UA SlipSpeed is a very grounded and minimally cushioned trainer. And it does feel that way on foot.

Measuring its heel stack with a calliper, we got a lower-than-average reading of 21.1 mm. Very similar to the Under Armour 670 (21.5 mm).

You can expect a sufficient amount of impact protection for walking and jumping sessions but it's not the same as the ultra-plush and cushy Under Armour Golf Polo tecnica blu.

The forefoot portion of the SlipSpeed also offers more ground feel than cushioning. With a calliper measurement of 19.2 mm, it is just the same as the average cross-trainer.

We found that it hits a sweet spot between shock absorption and ground feedback. Both rope jumps and lifting felt at home in this trainer.

We thoroughly enjoyed a sense of underfoot control in the UA SlipSpeed.

There is practically no heel elevation in the shoe due to the very minimal heel-to-toe drop (1.9 mm). It means that the heel is almost at the same level as the toes (as if you were standing barefoot on the floor).

It helped us feel more planted and activated the Achilles tendon more than usual. So, if you struggle with ankle mobility, particularly during deep squats, we advise going with a higher-drop shoe (at least 6 mm).

If you are familiar with Under Armour's basketball shoes or running footwear, you will be pleased to see the brand's Flow cushioning foam in the SlipSpeed.

But don't expect the same softness in this trainer. Pressing our durometer against the shoe's Flow midsole returned 28.5 HA which is slightly firmer than average.

But on the bright side, we encountered a similar level of elasticity and energy return as in the other UA shoes we tested. There was a welcome touch of bounce for high-impact exercises like box jumps and burpees.

We even found it comfortable enough for short warm-up runs on the treadmill!

A generously padded insole makes the shoe even more comfortable for short runs, plyometrics, and long hours on the feet.

Armour Forge Polo Mens.

The moment we slipped into the SlipSpeed, we could feel its snug one-to-one fit. And the fact that its synthetic upper is thick and has no stretch at all contributes to the skin-tight experience.

But now let's pour some gel into the shoe's toebox to figure out how snug we're talking...

As soon as the mould was ready, we measured its widest part with a calliper. The measurement confirmed our initial impression showing only 93.3 mm of width in the metatarsal area.

We think that athletes with medium-to-narrow feet will appreciate this UA trainer more than the wide-footed folks, especially since there is no wide version available.

It is also important to mention that the SlipSpeed's toebox gets progressively narrow towards the front.

Measuring the mould's width in the big toe area returned as little as 65.1 mm! This is a very rare case of sub-70 mm in the training shoe category.

On a lighter note, a close fit like that guarantees that this slip-on trainer won't go flying off your foot in the middle of the workout. It remains surprisingly secure during intense movements.

The SlipSpeed trainer also locks the toes pretty firmly from the top. A very minimal vertical space of 24.2 mm contributes to the shoe's overall snugness.

Working together with the bootie, the BOA closure provides a highly secure lockdown in the midfoot.

This toggle lacing system takes seconds to adjust and can be regulated with just one hand, on-the-go. The knob turns in 1-mm increments allowing us to fine-tune the fit. To release the hold, all we needed to do was to pull the knob up.

If you feel uncertain about the ultra-thin cables, there is no reason to be concerned. These strings are made of the strongest man-made fibre in the world which is also used for laying cable at the bottom of the ocean. And it has long proven itself on snowboarding boots to.

Generally, the SlipSpeed offers a solid footing with its low-to-the-ground, firm, and wide sole. But the shoe fails miserably when it comes to lateral support and containment.

Zapatos de trekking para hombre Under Armour.

Where most cross-trainers feature solid TPU reinforcements, the SlipSpeed doesn't have any supportive elements.

Under Armour Lockdown 5 Zwart Wit.

If your workouts involve a lot of heavy lifting and forceful lateral movements, or if you deal with overpronation (excessive inward rolling of the foot), you must get a more supportive trainer. We recommend looking towards the Reebok Nano X4 and the Under Armour 670.

You can clearly see how little structure there is to the UA SlipSpeed as we twist it effortlessly with our hands.

On a scale from 1 to 5, where 5 is the stiffest, we rated this trainer with the lowest score of 1. It is much more pliable than the average training shoe.

It is pretty obvious that the shoe's convertible heel offers pretty much no heel hold.

It is a completely different design from a typical cross-trainer. You have to choose between having a firm heel hold and the option to swap between a slip-on and a shoe.

Example of a 4/5 heel counter stiffness.

Once again, we advise going for a full-on supportive shoe if you have fallen arches or moderate/severe overpronation.

Looks like the SlipSpeed mostly Murray on its wide base for stability.

Notably wider than average, the shoe's platform creates extended contact points with the floor to give a better sense of control.

Measuring the widest part of the sole in the forefoot, our calliper showed 117.3 mm which is over 7 mm wider than average!

The SlipSpeed also turned out to be wider than average in the heel.

Under Armour Legacy sherpa jacket in stone Under Armour 670 (95.0 mm).

Having such a wide and flat base helped us feel surefooted when lifting and performing single-leg movements.

You can rest assured that the UA SlipSpeed bends enough to let you perform lunges, hold a plank, and walk around comfortably.

According to our shoe flexing tester, it only takes 9.9N of force to bend this shoe to a 30-degree angle. This is a little less than it takes an average training shoe.

On the flip side, a more flexible profile makes it trickier to lift heavy as we found it harder to ground toes on the floor. 

Under Armour Training x Project Rock Szary top bez rękawów z nadrukiem.

Weighing it in a men's US size 9, we got a below-average measurement of 10.2 oz (288g). Nice and light!

On foot, this Under Armour shoe feels like an actual slipper! It got us through the gym session and then the rest of the day without a hint of foot-dragging.

With its neoprene-ish inner bootie and thick synthetic outer shell, the SlipSpeed doesn't let much air in or out.

As you can see in our breathability test above, the shoe's upper barely allows the smoke to escape the interiors.

And even when we tried hovering its half-cut upper over the light, no secret ventilation holes showed up.

Sure, the shoe's upper is full of perforations. But the reinforced padding beneath it simply doesn't let them work full time.

So, let's get this straight - the SlipSpeed is NOT a breathable trainer. If we compare it to other training shoes on a 1-5 breathability scale, this UA shoe deserves no more than a 2. But then how did it manage to keep our feet cool?

The answer is Iso-Chill padding throughout the inner lining and on the tongue. These cooling pillows did a great job of regulating the temperature inside the SlipSpeed and prevented our feet from heating up in the first place!

Under Armour Kick Sprint!

A mere glance at the shoe's sturdy upper promises durability.

After exposing the shoe's toebox material to our Dremel for 12 seconds, we saw a ridiculously minor scuff where most shoes develop a large hole!

Rating its toebox durability on a 1-5 scale, we confidently gave it the highest score of 5!

This reinforced material can handle a lot more wear and tear than a typical training shoe. Slashing it against the floor or gym equipment won't be an issue at all.

The only potential problem with the SlipSpeed's upper is that it tends to crease and chip off more than other uppers. It doesn't affect the shoe's integrity or durability but takes some points away from the looks.

Under Armour is quick to call these shortcomings "battle scars" because they only appear if the wearer has been training "hard enough." That's one very market-y way to put it. 

Because the convertible heel collar is the shoe's main highlight, we had high expectations for this part of the SlipSpeed. Especially when it comes to wear resistance.

Luckily, the brand chose a rather durable textile for the inner lining of the heel counter. Given how much back-and-forth folding and sliding it is meant to withstand, we are happy with its performance in our durability test.

Coming in contact with our Dremel for 4 seconds, the fabric showed very small signs of wear. This earned the shoe's heel lining a solid durability score - 4 out of 5!

The absence of a rubber outsole left us puzzled, to be honest. If the SlipSpeed is meant as a versatile knock-around, then why did Under Armour leave its foam exposed to wear and tear?

And it's not a firm type of foam either. Pressing our durometer against it showed 57.5 HC which is a whopping 45% softer than the average of training shoes! That's not very good news for the shoe's long-term durability.

Under Armour Threadborne Fitted.

Meeting the sandpaper tip of our Dremel for 22 seconds, the shoe's foam was eaten alive. The tool burnt a hole as deep as 4.7 mm! That's over 3 mm deeper than average!

Unfortunately, we cannot recommend the Under Armour TriBase Reign 4 for prolonged outdoor use, especially on highly abrasive surfaces.

But if your most common areas of habitat are home, car, coffee shop, and gym, then this shoe will serve you well.

Granted, the SlipSpeed's exposed foam undercuts many rubber outsoles when it comes to grip.

Softer and toothier, the Flow foam bites onto smooth gym floors like there is no tomorrow.

With its lugs facing all fronts, we found it easy to stop on a sixpence and change directions on the fly.

Under Armour Hovr Summit Fat Tire Marathon Running Shoes Sneakers 3022946-500.

The "tongue" (or the instep padding) of the SlipSpeed is not very thick. Showing only 4.4 mm on our calliper, it is a bit thinner than average.

But we found it to be just right to buffer the pressure from the BOA cables.

As a mule, the Under Armour TriBase Reign 4 features a one-piece bootie upper that wraps around the foot with no gaps in between.

Because the shoe's insole is removable you can play around by replacing it with a custom orthotic to elevate the in-shoe comfort.

With convenience as its cornerstone, the SlipSpeed features a foldable heel collar that quickly turns the shoe into a slipper. You don't even need hands to push the collar down!

Switching gears from training to rest couldn't be any easier!

We found that there is a small pillow on the inner side of the foldable part. It Low as the Achilles pad when the collar is up but turns into a heel crash pad when you fold the collar.

But here is the caveat: if you have sensitive feet and prefer the bottoms of your shoes to be as smooth as the baby's bottom, you might be annoyed with the folded material beneath the heel.

To make the SlipSpeed even more enticing, Under Armour promotes it as machine washable. It is promised to last up to 200 wash cycles before starting to lose integrity.

Under Armour Heathered Blitzi Ανδρικό Καπέλο:

• Place the shoes in a laundry bag (it may or may not come with the shoe depending on the retailer you buy it from)
• Machine wash on cold delicate
• Allow shoes to air-dry (tumble drying is not recommended as it can heat up the glue and the foam)